Updated for 2013, now with deeper grooves between the teeth and sharper teeth but without becoming boot tearing 'bear traps'
Weld-on wide footpeg.
1 pair of 44mm wide pegs, serrated outer only.
Fitting instructions.
#Cut the old serrated part of the peg away and save the pivoting section to weld the new bit to.
or
Wrap around the old peg and raise slightly so your boot will sit on the new peg.
They are relatively easy to fit this way but can look a bit ordinary and may also fill with mud easier.
Where possible it is recommended to cut away the old serrated part of the peg for a more professional look.
# Stand behind the bike & squat down to check they are level. (parallel with each other)
# Stand beside the bike & squat down to check they are level. (front to back)
# Look down from top to see they are parallel with each other
Once they look right and you have them secure take them off the bike to fully weld.
They may require a small piece of flat steel underneath to reinforce the support for them, depending on fit.
Click image to enlarge.
More info.